Product Description
With the MMOBIEL Dock Connector Substitute Equipment, it is possible for you to to repair your telephone very quickly! The whole lot you want is inside this DIY Dock Connector Substitute Equipment.
CAUTION: Earlier than dissasembling your telephone, discharge your battery under 25%! A charged lithium-ion battery can catch hearth or explode if by accident punctured.
BEFORE YOU START: Please create a backup of your iPhone.
Step 1
Take away the 2 Pentalobe screws on the underside fringe of the iPhone.
Step 2
Use a Warmth Gun or Hair Dryer, to use delicate warmth to the decrease fringe of the iPhone, for approx. one minute.
Step 3
Apply a suction cup to the decrease left nook of the show meeting.Pull up on the suction cup with agency, fixed stress, to create a slight hole between the entrance panel and rear case.Place the flat fringe of a spudger into the hole between the display and rear case, instantly above the headphone jack, and twist the spudger to widen the hole.Slide the spudger up the aspect of the telephone to separate the adhesive and free the clips.
Step 4
Use the suction cup to open the show, breaking the final of the adhesive.CAUTION: Don’t open the show additional than 90º, as it’s nonetheless related on the prime by three cables that will break if stretched too far.
Step 5
Take away two Phillips screws securing the Battery Connector Bracket.Take away the bracket.
Step 6
Use the purpose of a spudger to disconnect the Battery Connector by prying it straight up from the logic board.
Step 7
Take away the our Phillips screws securing the Show Cable Bracket.Take away the bracket.
Step 8
Disconnect the Entrance Digital camera Flex Cable.Disconnect the Digitizer Flex Cable.Disconnect the Show Cable.
Step 9
Take away the entrance panel.
Step 10
Use the purpose of a spudger to carry and disconnect the antenna cable from the underside finish of the logic board.Use the purpose of a spudger to carry up and disconnect the Lightning connector ribbon cable from its socket on the logic board.
Step 11
Take away the three Phillips screws securing the Lightning connector bracket.Take away the bracket
Step 12
Use the purpose of a spudger to pry up and disconnect the antenna cable from the Dock Connector.Use the purpose of a spudger to pry up and disconnect the antenna cable from the highest of the logic board.Take away the cable.
Step 13
Take away the six Phillips screws securing the speaker to the rear case.
Step 14
Take away the Loud Speaker
Step 15
Use the purpose of a spudger to disconnect the Taptic Engine flex cable from the decrease flex cable.
Step 16
Take away the 2 screws securing the Taptic Engine.Take away the Taptic Engine.
Step 17
Take away the folllowing screws securing the Dock Connector flex cable.
Step 18
Insert a gap decide below the Dock Connector flex cable and slowly slice by the adhesive holding the cable to the rear case.
Step 19
Use a gap decide to pry the left microphone off the sting of the rear case.
Step 20
Insert the purpose of a spudger into the headphone jack and wiggle it barely to loosen the headphone jack from the underside fringe of the case.Take away the Dock Connector.Congratulations! You’ve got now efficiently eliminated your Dock Connector!To reinstall the iPhone, use the earlier steps on this handbook and apply them backwards.
Prime quality Skilled equipment – Incl 2 x screwdriver for Straightforward Set up! 100% correct alternative half
Straightforward Set up: With adhensive underside for a straightforward alternate! Prepared to make use of!
Compatibility:Appropriate solely with iPhone 6S Plus A1634 A1687 A1699! Prime quality product by MMOBIEL!
Prime quality product by MMOBIEL: Every half is examined earlier than cargo, Merchandise in Inventory!
